Produtcs | Rock and Concrete Splitters | C12
Can be used independently everywhere
Powerful in seconds
Low vibration and dust, almost noiseless
Economical and safe
Precise measurement can be controlled at any time
Robust and light
Options
and Accessories
Enlarging counter wedges
For enlarging the previously created crack. Particularly strong reinforcement can be broken off easily afterwards.
Pressure shells
For use with very heavily reinforced concrete or poor quality concrete. Core bore ø 100 mm ensures more surface area for better force transmission.
Special lubricant
Lubrication of the pressure surfaces of the wedge and the counter wedges guarantee maximum utilization of splitting force and reduction of wear. Water resistant.
C12 – the powerful
Splitter
Taking advantage of the low tensile strength of rock and concrete, the hydraulic splitting cylinders allow controlled, quiet and cost-effective demolition from the inside!
Our largest hand-held cylinder model is the world’s most powerful splitter in relation to its size. The C12 splitting cylinder breaks reinforced, lightweight, as well as unreinforced concrete equally reliably and is particularly suitable for heading concrete piles, as well as wall and masonry demolition.
The C12 splitting cylinder is particularly suitable for rock demolition, as well as secondary splitting of boulders. Through several splits, the structure of a full rock surface or rock area can be weakened and the rock can be easily excavated afterwards. In the natural stone industry, it is used for block quarrying of hard rock, as well as in tunnel driving and extension work in underground mining.
The handy Rock and Concrete Splitter has an enormous power-to-weight ratio. One person can work in any position and even under water, while other work continues in parallel: Low noise, without vibrations and flying rocks.
Conventional mechanical methods destroy the structure of the material by applying external force. Rock and concrete, however, can withstand very large compressive forces from the outside. In comparison, the resistance to a force acting from the inside out is relatively low. The development of the Darda Rock and Concrete Splitter was based on this fact.
Safe wedge
principle
First, a hole of the appropriate depth and diameter is drilled, into which the splitting insert of the splitting cylinder is then inserted and aligned to determine the splitting direction. With hydraulic pressure, the wedge pushes itself between the two counter wedges and presses them apart. The effective splitting force of up to 413 tons or 4048 kN destroys the structure of concrete and rock from the inside. A split is created in a matter of seconds. Thinner reinforcing bars in reinforced concrete tear off.
A complete
Splitting Unit
consists of three
components:
1. Hydraulic Splitter
2. Hydraulic Power Unit
3. Hydraulic hose set (high and low pressure)
Further
Models
News and
Stories
